This is by far the easiest way to make Printed Circuit Boards from CAD software or magazine PCB layout artwork.
You simply make the PCB image by putting a Press 'n' Peel sheet of transfer film in the paper tray of a photocopier or Laser Printer (The sheet size is almost the same as the A4 paper tray). You then print or copy the PCB track image onto the film. Using a domestic clothes iron you press the image onto a precleaned piece of copper clad PCB. The image transfers to the copper and the image will not etch away. Ammonium Persulphate or Ferric Chloride are both OK.

You get 5 sheets of 215 x 280mm transfer film in each pack.
Full instructions supplied.
4 Easy steps
1. Print or Copy
2. Iron on
3. Peel off
4. Etch